[canmet] Add report files for all the scenarios

2013-canmet/s04/s04_t01_2013-06-21_10:52.txt

@@ -0,0 +1,2 @@
+The client terminal is on the wooden table, its antenna is at 10 cm from
+CP3's antenna, in direction of the middle of the tunnel.

2013-canmet/s04/s04_t02_2013-06-21_11:00.txt

@@ -0,0 +1,3 @@
+The client terminal is on top of CP3. Its antenna's base is 13 cm above
+the base of CP3's antenna. Horizontally, the two antennas are only a
+couple of cm apart.

2013-canmet/s05/s05_t01_2013-06-20_13:44_middle.txt

@@ -0,0 +1,3 @@
+The client terminal is not located precisely between RB2 and RB3, it is:
+- at 32.50 m from RB3
+- at 31.50 m from the door (31.70 m from RB2)

2013-canmet/s05/s05_t02_2013-06-21.txt

@@ -0,0 +1,10 @@
+The client terminal is located precisely:
+- at 32 m from CP3
+- at 32 m from the door (32.20 m from CP2)
+
+When on the east side of the tunnel, the terminal is between 5 and 15 cm
+away from the wall (depending where the distance measurement is taken),
+and is not in line of sight with CP2.
+
+When on the west side, it is between 5 and 10 cm away from the wall and
+is in line of sight with the two CPs.

2013-canmet/s07/s07_t01_2013-06-25_11:09.txt

@@ -0,0 +1 @@
+The client terminal is located precisely under CP1.

2013-canmet/s07/s07_t02_2013-06-25_11:23.txt

@@ -0,0 +1,3 @@
+The client terminal is located at 1.20 m from the position of t01 (i.e.
+under CP1) in the direction of the south wall (or, more precisely, the
+south-south-west wall).

2013-canmet/s13/s13_t01_2013-06-25_09:52.txt

@@ -0,0 +1,4 @@
+In this test, the access point was located in the operation room (south
+of CP3), therefore it is not guaranteed that the mobile terminal could
+always send positioning requests successfuly, and a lot of retry packets
+have probably been transmitted.

2013-canmet/s14/s14_t01_2013-06-25_11:40.txt

@@ -0,0 +1,3 @@
+The client is located at the first intersection at the west of CP1, at
+33 m from CP1, in line of sight, and at 1.60 m from the south wall of
+the tunnel.

2013-canmet/s14/s14_t02_2013-06-25_11:56.txt

@@ -0,0 +1,4 @@
+The client terminal is located 10 m north of the position of t01, a few
+metres south of the north-west/north-east bifurcation. Therefore, it is
+at 11.60 m from the south wall. It is not in line of sight with CP1 any
+more.

2013-canmet/s21/s21_t01-03_2013-06-25_12:30.txt

@@ -0,0 +1,40 @@
+The three tests were done in a row, just by deactivating the access
+point for 30 seconds between two tests, and generated one big
+aggregation file. Here is the detailed (but approximate) timing of the
+three tests:
+
+- T0: AP started (12:30)
+  - Elapsed:    00m 00s .00
+  - Total time: 00m 00s .00
+- T1: t01 started
+  - Elapsed:    00m 06s .50
+  - Total time: 00m 06s .50
+- T2: AP stopped
+  - Elapsed:    05m 05s .75
+  - Total time: 05m 12s .25
+- T3: AP started
+  - Elapsed:    00m 37s .02
+  - Total time: 05m 49s .27
+- T4: t02 started (12:36)
+  - Elapsed:    00m 14s .99
+  - Total time: 06m 04s .26
+- T5: AP stopped
+  - Elapsed:    05m 07s .29
+  - Total time: 11m 11s .55
+- T6: AP started
+  - Elapsed:    00m 34s .48
+  - Total time: 11m 46s .03
+- T7: t03 started (12:42)
+  - Elapsed:    00m 06s .97
+  - Total time: 11m 53s .00
+- T8: AP stopped
+  - Elapsed:    05m 09s .06
+  - Total time: 17m 02s .06
+
+This timing is approximate because the chronometer was started only
+after the given action had begun (because the chronometer was an app
+running on the smartphone-access point, it was not possible to start
+both the access point and the chronometer at the exact same time).
+
+We assume time T0 is 12:30, but the precise hour was not wrote down at
+the time. No big deal though.

2013-canmet/s21/s21_t01_2013-06-25_12:30.txt

@@ -0,0 +1,3 @@
+In this test, the human operator stands still at the same position as
+for the scenario 01, i.e. at 2 m from the west wall, and faces this
+wall.

2013-canmet/s21/s21_t02_2013-06-25_12:36.txt

@@ -0,0 +1,2 @@
+This test is similar to t01, except the operator stands at 30 cm from
+the wall.

2013-canmet/s21/s21_t03_2013-06-25_12:42.txt

@@ -0,0 +1,4 @@
+In this test, the operator stays in the same area but can be in motion,
+his orientation changes (sometimes he faces one of the three walls,
+sometimes he turns in the direction of CP6), he can walk nearer of
+further the walls, etc.

2013-canmet/s22/s22_t01-02_2013-06-25_13:07.txt

@@ -0,0 +1,15 @@
+t01 is the path towards CP5, and t02 is the return, from CP5 to the
+emergency exit. Both tests were done in a row and generated only one
+big aggregation file.
+
+t01 started approximately at 13:07, and t02 finished approximately at
+13:30, but some time passed between the two tests:
+
+Timestamp of the last request of t01: 1368650837.872503991
+Timestamp of the first request of t02: 1368651254.630584995
+Difference: 416 seconds = about 6 minutes 56 seconds
+
+t02 finished approximately at 13:15, and t01 started around 13:22.
+
+Each test itself lasted about 7 minutes 30 seconds. See the dedicated
+report files for precise timing.

2013-canmet/s22/s22_t01_2013-06-25_13:07.txt

@@ -0,0 +1,43 @@
+- T0: AP started (emergency exit)
+- T1: start walking
+  - Elapsed:    00m 08s .72
+  - Total time: 00m 08s .72
+- T2: AP stopped (RB6)
+  - Elapsed:    00m 53s .90
+  - Total time: 01m 02s .62
+- T3: AP started
+  - Elapsed:    00m 34s .13
+  - Total time: 01m 36s .75
+- T4: start walking
+  - Elapsed:    00m 06s .12
+  - Total time: 01m 42s .87
+- T5: AP stopped (RB3)
+  - Elapsed:    01m 07s .39
+  - Total time: 02m 50s .26
+- T6: AP started
+  - Elapsed:    00m 35s .51
+  - Total time: 03m 25s .77
+- T7: start walking
+  - Elapsed:    00m 06s .62
+  - Total time: 03m 32s .39
+- T8: AP stopped (RB2)
+  - Elapsed:    00m 55s .27
+  - Total time: 04m 27s .66
+- T9: AP started
+  - Elapsed:    00m 32s .93
+  - Total time: 05m 00s .59
+- T10: start walking
+  - Elapsed:    00m 06s .11
+  - Total time: 05m 06s .70
+- T11: AP stopped (RB1)
+  - Elapsed:    00m 59s .75
+  - Total time: 06m 06s .45
+- T12: AP started
+  - Elapsed:    00m 33s .73
+  - Total time: 06m 40s .18
+- T13: start walking
+  - Elapsed:    00m 06s .38
+  - Total time: 06m 46s .56
+- T14: AP stopped (RB5)
+  - Elapsed:    00m 51s .57
+  - Total time: 07m 38s .13

2013-canmet/s22/s22_t02_2013-06-25_13:22.txt

@@ -0,0 +1,43 @@
+- T0: AP started (RB5)
+- T1: start walking
+  - Elapsed:    00m 05s .50
+  - Total time: 00m 05s .50
+- T2: AP stopped (RB1)
+  - Elapsed:    00m 52s .27
+  - Total time: 00m 57s .77
+- T3: AP started
+  - Elapsed:    00m 33s .68
+  - Total time: 01m 31s .45
+- T4: start walking
+  - Elapsed:    00m 05s .82
+  - Total time: 01m 37s .27
+- T5: AP stopped (RB2)
+  - Elapsed:    01m 01s .23
+  - Total time: 02m 38s .50
+- T6: AP started
+  - Elapsed:    00m 33s .76
+  - Total time: 03m 12s .26
+- T7: start walking
+  - Elapsed:    00m 05s .98
+  - Total time: 03m 18s .24
+- T8: AP stopped (RB3)
+  - Elapsed:    00m 54s .46
+  - Total time: 04m 12s .70
+- T9: AP started
+  - Elapsed:    00m 34s .10
+  - Total time: 04m 46s .80
+- T10: start walking
+  - Elapsed:    00m 05s .62
+  - Total time: 04m 52s .42
+- T11: AP stopped (RB6)
+  - Elapsed:    01m 03s .43
+  - Total time: 05m 55s .85
+- T12: AP started
+  - Elapsed:    00m 35s .37
+  - Total time: 06m 31s .22
+- T13: start walking
+  - Elapsed:    00m 05s .75
+  - Total time: 06m 36s .97
+- T14: AP stopped (emergency exit)
+  - Elapsed:    00m 43s .69
+  - Total time: 07m 20s .66

2013-canmet/s24/s24_t01_2013-06-25_14:09.txt

@@ -0,0 +1 @@
+This test lasted about 2 minutes 30 seconds, to end at 14:11.

2013-canmet/s31/s31_t01_2013-06-26_10:07.txt

@@ -0,0 +1,32 @@
+This test is split is six sections, corresponding to six aggregation
+files.
+
+1 : from the starting point to CP6
+- starting measurements: 10:07:11
+- starting to drive: 10:07:50
+- stopping at CP6: 10:08:30
+
+2: from CP6 to CP3
+- starting measurements: 10:09:10
+- starting to drive: 10:09:38
+- stopping at CP3: 10:10:44
+
+3: from CP3 to CP2
+- starting measurements: 10:12:14
+- starting to drive: 10:12:37
+- stopping: 10:13:34
+
+4: from CP2 to CP1
+- starting measurements: 10:14:14
+- starting to drive: 10:14:43
+- stopping: 10:15:47
+
+5: from CP1 to CP5
+- starting measurements: 10:16:16
+- starting to drive: 10:16:42
+- stopping: 10:17:54
+
+6: from CP5 to the west intersection
+- starting measurements: 10:21:23
+- starting to drive: 10:21:55
+- stopping: 10:23:00